Technical assistance

We want to clear the main technical questions that may arise about the operation of our products and the steps necessary for their assembly.

Concept drawer

The formula is: internal module width -70. For this particular case, the internal width of the module will be 800 - 32 = 768 mm. From this measurement we subtract 70 to get the length to cut the profiles = 666 mm.

Yes, as long as you have a 13 mm wide square railing , or a straight rib with a minimum internal height of 135 mm and width of 13 mm. If I have a 800 mm wide module, and a 16 mm thick side panel.

It is only necessary to connect the machine to air with a pressure of 7-8 kg/cm2

In order to assemble a kitchen drawer with hinges on the unit doors (hinged doors) it is necessary to use hinges with an opening angle of 165ª or to use spacers, doing so means there will be enough space to pull out the drawer.

In order to assemble the aluminium back on the Concept drawer it is necessary beforehand to mount the accessories corresponding to each side height onto the profile. Subsequently, we will fasten the profile to the sides of the drawer.

Due to the fact there is separate assembly on the drawer, you can mount the Concept rails on other models of drawers. However, it is not advisable, as each drawer has its own rails and its own machining distances.

The board cutting dimension and the position of the hook on the front are different. However, the hole pattern of the guide rail is the same for the Concept, Vantage-Q and Slim drawers.

The RAL code of the anthracite grey finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 7043.The RAL code of the white finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 9003. Although it is necessary to bear in mind that the white silk colour of said drawer is metallized and the RAL codes are for flat colours.

It is only necessary to connect the machine to air with a pressure of 7-8 kg/cm2.

Yes, the drawer measurements, including its dimensions and machining, are fully compatible. The board cutting measurements, mounting dimensions and placement of the drawer in the module are exactly the same.This allows customers to mount 30 kg Concept slides and 50 kg slides on the same drawer.

The following video shows how you can easily assemble the Concept drawer.

The following video shows how you can easily assemble the Concept drawer with back panel.

No, it has a different profile and plastic accessories, because the height of the ribs is different from those of the Concept drawer.The front rail used for the interior drawer height of H178 mm is the same as that used in the H185 mm Concept drawer.

Subscribe to notifications
You're subscribed to notifications
You've blocked notifications
Click to subscribe to notifications
Thanks for subscribing!
You're subscribed to notifications
You won't receive notifications again
Manage Site Notifications
SUBSCRIBE
UNSUBSCRIBE
Unblock Notifications
Follow these instructions to allow notifications: